Publicidad
Idiomas disponibles
Idiomas disponibles
GLOSSARY OF TERMS
LOW-KICKBACK CHAIN
A chain that complies with the kickback
performance requirements of ANSI B175.1 when
tested on a representative sample of chain saws.
NORMAL CUTTING POSITION
Those positions assumed in performing the
bucking and felling cuts.
NOTCHING UNDERCUT
A notch cut in a tree that directs the tree's fall.
REAR HANDLE
The support handle located at or toward the rear
of the saw. It normally contains the switch trigger.
This handle is for the right hand.
REDUCED KICKBACK GUIDE BAR
A guide bar which has been demonstrated to
reduce kickback significantly.
FEATURES
PRODUCT SPECIFICATIONS
Motor ................................................................................................................................... 40 Volt DC
Bar Length .................................................................................................................................... 14 in.
Chain oil tank capacity ..................................................................................................................
NOTE: This saw was designed for occasional light duty use and has some limitations as to what it can cut.
KNOW YOUR CHAIN SAW
See Figure 4.
The safe use of this product requires an under-
standing of the information on the tool and in this
operator's manual as well as a knowledge of the
project you are attempting. Before use of this
product, familiarize yourself with all operating
features and safety rules.
CHAIN TENSIONING SCREW
This feature allows user to adjust the tension of
the chain.
GUIDE BAR
The factory-equipped guide bar has a small
radius tip that offers a somewhat lower kickback
potential.
REPLACEMENT SAW CHAIN
A chain that complies with the kickback
performance requirements of ANSI B175.1 when
tested with specific chain saws. It may not meet
the ANSI performance requirements when used
with other saws.
SAW CHAIN
A loop of chain having cutting teeth that cut the
wood, and that is driven by the motor and is sup-
ported by the guide bar.
SPRINGPOLE
A small tree (sapling) or limb that is bent or trapped
under tension. It may "spring back" rapidly when
cut, causing a dangerous situation.
SWITCH TRIGGER
A device that when operated will complete or
interrupt an electrical power circuit to the motor
of the chain saw.
LOCK-OUT BUTTON
A control feature designed to prevent the motor
from being accidently started.
LOW KICKBACK CHAIN
The low kickback chain helps minimize the force
of a kickback reaction by preventing the cutters
from digging in too deeply at the kickback zone.
QUICK VIEW OIL INDICATOR
Semi-transparent oil reservoir that allows user to
see when to add oil.
SWITCH TRIGGER
Squeeze the switch trigger to operate the unit after
switch lock-out has been pushed in. Release the
switch trigger to stop the unit.
10 – English
6 oz.
Publicidad
