Descargar Imprimir esta página

Blaupunkt 5VT7X00EME Instrucciones De Uso página 92

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 294
Problem
Dirty wash cabinet
White film on the inner
surface
Rust stains on cutlery
Knocking noise in the
dishwasher
Rattling noise in the
dishwasher
Knocking noises in the
water pipes
The dishes are not clean
Possible causes
Spilled detergent
A detergent with dye
may have been used.
Minerals in hard
water.
The items concerned
are not corrosion-
resistant.
A programme was
not executed after
salt was added to the
dishwasher. Traces
of salt have entered
the wash cycle.
The softener cap is
loose.
A spray arm is
knocking against an
item in one of the
baskets.
Dishes loaded loosely
in the dishwasher.
May be caused by
the on-site installation
or the cross-section
of the pipeline.
The dishes were
loaded improperly.
The programme was
not strong enough.
42
What to do
Always wipe up any spilled rinse aid
immediately.
Make sure that the detergent contains no
dyes.
To clean the interior, use a damp sponge with
dishwashing detergent and wear rubber
gloves. Never use any detergent other than
dishwashing detergent, as it can cause foam
or suds to form.
Avoid washing items that are not corrosion-
resistant in a dishwasher.
Run a wash programme without dishes each
time you add salt. After adding salt, do not
select the Turbo function (if available).
Check that the cap of the softener is securely
fastened.
Stop the programme and rearrange the items
obstructing the spray arm.
Stop the programme and rearrange the dishes.
Does not affect the functioning of the
dishwasher. In case of doubt, contact a
qualified installer.
See "Preparing and loading dishes".
Select a more intensive programme.

Publicidad

loading