Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the fuse
If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Flash-rate:
Colour-wheel:
Rotating gobo-wheel:
Maximum PAN-movement:
Maximum TILT-movement:
Length of base:
Width of yoke:
Height (head horizontal):
Weight (net):
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
OMNILUX EHJ 24V/250W G-6.35 50h 3000K
GE EHJ A1/223 24V/250W G-6.35 50h
OSRAM EHJ 64655HLX A1/223 24V/250W G-6.35
EUROLITE DMX Operator 192 Kanal
EUROLITE DMX Scan Control 192 Kanal
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 30.05.2006 ©
230 V AC, 50 Hz ~
335 W
7/9
3-pin XLR
13 Hz
7 dichroic filters and open
7 gobos and open
360°
250°
300 mm
300 mm
420 mm
12.5 kg
:
45° C
a
(steady state):
80° C
B
0.5 m
0.5 m
F 4 A, 250 V
No. 88289005
No. 88289000
No. 88289010
No. 70064520
No. 70064525
No. 51860102
No. 51860110
No. 51834001
33/63
51786500_V_1_1.DOC
Publicidad
