DeWalt DCST922 Manual De Instrucciones página 14

English
Accessories
WARNING:

those offered by D
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
D WALT recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact D
(1-800-433-9258) or visit our website: www.dewalt.com.
Replacement Accessories
Replacing Spool Assembly (Fig. A, N)
1. Rotate the spool housing
the spindle plate aligns with notch
housing. Insert a screwdriver through the notch and into
the hole, to prevent the spindle from turning.
2. Unscrew and remove the spool housing by turning the
spool grip cover 29 clockwise.
nOTE: Do not try to remove the spool by turning the
spool housing 28 .
3. Remove spindle plate
Remove any dirt and grass from the motor housing and
spindle plate.
4. Install spindle plate 34
double D shaped retaining nut on the spindle sits inside
the base of the spindle plate.
5. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new spool
housing counterclockwise. Securely tighten the new
spool housing onto the spindle
Fig. N
31
29
30
12
Since accessories, other than
WALT, have not been tested with
e
WALT call 1-800-4-D WALT
e e
10 until the hole 31
32 in the motor
34 before installing a new spool.
onto the spindle 33 , so the
33 .
32
34
33
Replacing Guard (Fig. O)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use D
guard Part Number N496261.

WARNING:
without guard firmly in place.
1. Remove the 2 guard screws
2. Attach the new guard as described in the Attaching
Guard section.
Fig. O
21
in
Folding for Storage or Transportation (Fig. P)
The string trimmer can be folded for storage or
transportation. To put the string trimmer in the folded
position, please refer to Extending and Folding the Pole.
Fig. P
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.
WARNING:
28 
and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a D
service center or a D
Always use identical replacement parts.
WALT replacement
e
Never operate appliance
21 .
To assure product SAFETY
WALT factory
e
WALT authorized service center.
e