Plein Air CMT-2000 Manual De Instrucciones página 14

Power Knob
Thermostat knob
During operation the fan heater must be at a minimum distance of 50 cm from walls or other objects. Direct the
air flow towards such a point so that room heating is optimised. Do not direct the heat flow towards corners or
reduced spaces, or towards the floor or ceiling.
1. The fan heater is equipped with two levels of heating power: to have the minimum power, turn the power
knob to position "I" and to have the maximum power turn it to position "II".
2. To heat a room quickly, set the fan heater to its maximum position (activate both power buttons). Once the
room has reached an agreeable temperature, set the fan heater to a lower position in order to reduce
consumption and to prevent the room from getting too hot.
3. Select low or maximum heat emission; set the desired temperature through the thermostat. By means of the
thermostat it is possible to adjust the temperature gradually. Once the desired temperature has been reached,
the appliance turns off automatically. When the temperature falls below the set level, the fan heater is
activated again.
4. For the ventilation function, turn the power knob on the ventilated position
5. The fan heater features the practical oscillation mode, which can be activated by turning the power knob on
position .
6. In order to unplug the appliance, select "
7. Before disconnecting the plug from the mains socket, switch off the appliance; it is advisable to activate the
ventilation mode for 30-60 seconds, in order to protect the appliance internal components from overheating.
SAFETY MEASURES
To avoid damages and dangerous situations caused by overheating, the fan heater is equipped with a safety
device that stops its operation in case of overheating, for example, due to a total or partial obstruction of the
grills. In this case, disconnect the appliance from the mains socket, wait for around 30 minutes so that it cools
down, and remove the object that is obstructing the grills. At this point, it is possible to start the appliance
again, as described above. The appliance should operate correctly. Should the problem come up again, contact
the nearest support centre.
To ensure its safe use, the appliance features a tip-over protection system. In case of accidental fall, the
appliance turns off automatically. CAUTION: If the heater is straightened, automatically restarts.
MAINTENANCE
1. This appliance requires no maintenance except cleaning of its external surface and filters.
2. Before cleaning the appliance, disconnect it from the mains socket and wait for it to cool down.
3. Dust the intake grill regularly, removing threads, down or any other foreign matter that might limit regular
air circulation.
4. To clean external surfaces, use only a soft moistened cloth. Do not use solvents.
5. Do not throw the box, use it to store the equipment.
6. When you don't use the appliance, store it in its original packaging and store in a dry place.
7. If the appliance has not been used for a long time, it is advisable to clean its filters at first re-use.
INSTRUCTIONS FOR DISPOSAL
Disposal of this product shall be governed by the European Community Directive 2012/19/UE on Waste
Electrical and Electronic Equipment (WEEE). According to this regulation, the consumer has the
obligation NOT to dispose of this product as household waste but through separate channels of collection
(WEEE). In the case of purchasing a similar new product, this product can be disposed free of charge from
DT Istr (CMT-2000) 03/09 – Rev.5_05/18
●
" OFF
"
Fan function: cold air flow
Heating function at minimum power
"I"
"II" Heating function at maximum power
Auto swing function
The fan heater is equipped with a thermostat for temperature
adjustment. Turn the adjustment knob clockwise to increase
the temperature (and, therefore, the power). Turn the
adjustment knob anticlockwise to reduce the temperature
(and, therefore, the power).
●
".
CMT-2000
.
14/25