SATYCON UNI100 Manual De Instrucciones página 7

TODO en 1/ALL in One: UNI100­UNI600
2. Set up By Manual Search:
If you have used all the codes under the brand name, the remote control still does not work(i.e. the device
still can not be controlled by this remote control),or you can not find the correct brand in the Device Code
List, you can use Manual Search to find out the correct code.
C. Power on the device that you want to control. If it is a VCR/CD/LD/VCD/DVD, it must be inserted with
a tape/disk.
D. Press and hold [SET] key and press the device key(TV1 etc)at the same time.
E. The LED will be on at the moment.
Then release the pressed both keys.
F. Press the [SET] key again, then release it, The remote control enters into Manual Search Mode and
the LED keeps flashing.
G. Point the remote control to the device, and then press and release the [POWER] key slowly. See if
the device reacts or not. If it reacts, turn to step F .If not ,repeat step E(press the [power])every 1
second.
H. Test other keys, if they do not work good enough, return to step A.
Remarks:
A . Because Some device work slowly for the POWER signal, In search process, you can press[SET] key
to switch between Forward and Backward to change search direction and find the right code quickly.
E. Whenever you want to leave search mode, press the device key, and the LED will turn off.
F. In the search mode, besides the [POWER] key, all other key's function can be checked normally,
That is to say you can test other keys without leaving search mode.
G. The remote unit will leave search mode automatically if no key is pressed in 30 seconds.
3. Set Up By Auto Search:
This search is similar to Manual Search but the remote control transmit the power signal automatically
instead of manually pressing power key.
D. Power on the device you want to control. if it is a VCR/CD/LD/VCD/DVD, it must be inserted with a
tape/disk.
E. Press and hold [SET] key, in the meantime, press and hold the[POWER] key for more than 3
seconds and then release them, the auto search begin. The remote control enters into Auto Search,
LED flashing, and remote control transmits power signal every 2.0 seconds automatically.
F. See if the device react or not, once the device reacts, press any key(except SET key) to stop the
auto search.
G. Test if the other keys work good enough. If most keys work not good enough, please go to step B-D
using Auto Search again to find the best code.
Remark:
D. whenever you want to leave Auto Search mode, press any key (except SET key) to quit, and the
LED will be off. The search is over.
E. When remote control searches through all different type of codes (about 5 minutes), LED will have
been on for 2 seconds, then the remote control will quit from search process automatically.
F. In case of you do not stop the auto search on time when you find the device react, you may use
Manual Search to search back to find the reactive code.
4. Device code display:
The device code is a 3-digit number and any one of the digits can be indicated:
D. Press and hold the [SET] key, in the mean time press the digit that you want to display, such as
1,2or3.
www.satycon.com Página 7