Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
1. Familiarize yourself with the jack.
2. Line up the bottom of handle to the release valve located under the handle socket. Turn handle and release
valve Clockwise to Tighten.
3. Secure the handle in place inside the handle socket. Without any vehicle on the jack, cycle the lift up and
down several times to insure the hydraulic system is operating properly. (Perform the System Air Purge
Procedure before first use.)
SYSTEM AIR PURGE PROCEDURE
IMPORTANT: BEFORE FIRST USE
Perform the following System Air Purge Procedure to
remove any air that may have been introduced into
the hydraulic system as a result of product shipment
and handling. This step is to be completed without
any weight on the jack.
1. Turn release valve counterclockwise one full turn
to the open position.
2. Remove cover plate.
3. Rapidly pump the handle 6-8 times. Leave handle
in down position to expose oil fill plug.
4. With a flat blade screwdriver, push the oil fill
plug slightly to the side to purge trapped air from
system. (Use caution not to tear or puncture the
oil plug.)
5. Replace cover plate and the jack is now ready for
use. Check for proper pump action.
6. Turn release valve clockwise to the closed
position.
7. Jack is now ready for use. Check for proper pump
action. (Repeat steps if neccessary).
3
Publicidad
