Publicidad
Idiomas disponibles
Idiomas disponibles
4
OPEN/CLOSE
TAPE
TIMER/CLOCK ADJ
DISPLAY MODE
STANDBY/ON
OPEN/CLOSE
Function select buttons
功能選擇按鈕
Teclas de selección de función
24
En
All manuals and user guides at all-guides.com
TUNER/BAND
AUX
CD
DISPLAY
JOG
JOG
SET
23/8
Getting Started
Switching on and setting the
clock
You should now have your system installed with everything
connected up and plugged in. After switching on, the first thing to
do is to set the clock. This only needs to be done once (unless all
power to the unit is cut) and will enable you to use the timer
features.
Use the front panel controls to do this.
1 Press STANDBY/ON
• Pressing again switches the unit back into standby mode.
2 Press TIMER/CLOCK ADJ.
3 Turn the JOG dial until CLK ADJ (clock adjust) appears
in the display.
If this is the first time you've switched on the unit,
should already be displayed.
4 Press SET.
5 Turn the JOG dial to select 12 or 24 hour clock
format.
This setting affects the clock and timer setting displays. Choose the
format you prefer.
6 Press SET.
7 Use the JOG dial to set the hour.
8 Press SET.
9 Use the JOG dial to set the minute.
10 Press SET to finish.
• Press
(front panel) or
DISPLAY MODE
anytime to show the current time. The display will revert to its
previous state after about five seconds.
Tip
There are a number of buttons other than
will switch the unit on. Pressing any of the function select buttons
(
,
/
,
CD
TUNER
BAND
TAPE I
standby mode will turn the unit on and switch to that function.
Pressing the disc tray
OPEN
power on and select the CD function.
If you press
with a disc loaded, the disc will also start playing.
CD
Likewise, if there is a tape loaded and you press
tape will begin playing.
Pressing 2 6 will switch on the power and start playing the
last selected function.
CLK ADJ
(remote)
DISPLAY
/
which
STANDBY
ON
/
,
) when the unit is in
II
AUX
/
button will also switch the
CLOSE
/
, the
TAPE I
II
Publicidad
