Troy Lee Designs A3 Manual Del Propietário página 6

EN
7
9
8
7. TWIST STABILIZER WHEEL (AT REAR OF HELMET) CLOCKWISE
TO TIGHTEN AGAINST THE BACK OF THE HEAD. TIGHTEN UNTIL
HELMET FITS SNUG AND SECURELY. TWIST STABILIZER WHEEL
COUNTER-CLOCKWISE TO LOOSEN TENSION AGAINST BACK OF
HEAD TO REMOVE HELMET.
8. ADJUST STABILIZERS REACH ON BACK OF HEAD BY GENTLY
PULLING OUT END OF ARM PROTRUDING INTO HELMET SHELL.
LOCATE THE END OF THE STABILIZER BALL MOUNT IN ONE OF THE
THREE HOLES FOR DESIRED FIT. PUSH TO CLICK FOR SECURE
MOUNTING.
9. INSTALL LINER USING SPECIFICALLY LOCATED VELCRO
MOUNTING POINTS. LINER WILL STICK TO VELCRO AND HOLD
LINER INTO POSITION. INSERT LINER INTO SHELL BY STARTING AT
THE FRONT OF THE FOREHEAD, SECURING THE LINER TO VELCRO
MOUNTS AS YOU WORK TO THE BACK OF THE HELMET.