Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7.6
INSTALL THE SIDE DISCHARGE
CHUTE
12
When you use the side discharge chute,
•
Do not install the grass catcher.
•
Keep the mulch plug installed.
1. Open the side discharge flap and hold it.
2. Line up the recesses of the side discharge chute (12)
below the pivot (19).
3. Close the side discharge flap.
7.7
SET THE CUTTING HEIGHT
The machine can be set to different cutting height.
1. Pull the height adjustment lever (8) rearward to increase
the cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
19
CAUTION
8
English
7.8
INSTALL THE BATTERY PACK
20
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
•
Read, know, and follow the instructions in the battery
and charger manual.
The machine has an automatic switch function that lets the
other battery work when the first cannot operate.
1. Open the battery door (20).
2. Align the ribs on the battery pack with the grooves in the
battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The motor starts only when you put in the safety key (22).
7.9
REMOVE THE BATTERY PACK
1. Open the battery door (20).
2. Remove the safety key (22).
3. Push and hold the battery release button (21).
4. Remove the battery pack from the machine.
8
OPERATION
Wear eye protection during operation.
10
22
21
WARNING
NOTE
NOTE
WARNING
Publicidad
