Descargar Imprimir esta página

Dyna-Glo EG7500DG Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

ITEM
PRECAUTIONS - SAFETY GUIDE .................................................
1. DESCRIPTION ..........................................................................
2. SPECIFICATIONS .....................................................................
3. GENERAL SAFETY INFORMATION ........................................
4. LOCATING HEATER .................................................................
5. INSTALLATION .........................................................................
6. OPERATING INSTRUCTIONS .................................................
7. MAINTENANCE ........................................................................
DESCRIPTION
Electric utility heaters are designed to meet a variety of heating requirements by switching
a few wires located in the base of the unit. Heat output is 25 589 BTU per hour. Features
horizontal and vertical flow horizontal air flow. Built-in thermostat with overheating safety
thermal cutout.
SPECIFICATIONS
BTUs: 21,331 / 25,589
Power: 6,250 / 7500W
Volts: 240V / 60HZ
GENERAL SAFETY INFORMATION
This heater requires hardwire installation (no plug). The installation of this
product must be carried out by a certified electrician and in accordance
with all local and national electrical codes.
NOTE: Compatible with a 240V Line Voltage Double Pole Wall Thermostat.
Must be installed by a Certified Electrician.
Read and understand all installation & operation instructions prior to
operating this unit. Observe all safety instructions.
1. Use only copper wires rated for at least 75ºC.
2. Heater air flow must be directed parallel to or away from adjacent wall.
3. Observe all wall, floor and ceiling clearance requirements.
4. All wiring must be done according to national and local electrical codes. The
heater must be grounded as a precaution against possible electrical shock.
Heater circuit must be protected with proper fuses.
5. The mounting structure and the anchoring hardware must be capable of
supporting the weight of the heater and the mounting bracket (if used).
CONTENTS OF USER'S MANUAL
WARNING
WARNING
3
PAGE #
1
3
3
3
5
5
10
11

Publicidad

loading