Descargar Imprimir esta página

Dimplex BLF3451-INT Manual Del Propietário página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

Fireplace Installation
Figure 6
Mounting
hole
Ensure that the 3-Position Switch is
set to the Off position ("O") and that
the circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
3. Lift fireplace and insert into
opening (Figure 5).
4. Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive
four
mounting
the four (4) mounting holes
located in each corner of the
fireplace chassis, into wall
studs (Figure 6).
6. Refer
to
Installation section, for final
installation procedures.
Flush Mounted Installation
(4)
supplied
screws
through
Front
Glass
- 200mm Deep
CAUTION: Two people may
be required for various steps of
this procedure.
1. Prepare a wall with a framed
opening of 83.8 cm wide x 47
cm high (Figure 7).
!
NOTE: The sizing has allowed
for 6.4mm around the fireplace
insert for ease of installation. This
fireplace does not require any
additional venting.
2. Choose
supplying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
Figure 7
your
method
of

Publicidad

loading