Trust ZSDR-850 Manual De Instrucciones página 8

EN
ZSDR-850 SMOKE DETECTOR
1
B Place the detector on the mounting bracket.
2
Secure the detector by twisting it on the bracket to lock it.
6. TEST MODE
Activate the test mode of the detector to check the operation by pressing the Test/Stop button. The LED will flash fast and
the detector will sound.
RESET DETECTOR AND ACTIVATE CONNECT MODE
Warning: This step will disconnect the detector from the Smart Bridge or the ICS-2000. To reset the detector press the
button in the hole at the side for approximately 5 sec with the included pin. The LED will flash 6x to confirm the reset.
Activate connect mode: After resetting the detector you can activate the connect mode by
pressing the button in the hole on the side for approx. 2 sec. The LED will flash fast for 1 minute to indicate the connection
mode.
REPLACE BATTERY
A
Open the battery compartment by removing the detector from the bracket.
B
Remove the empty battery and insert a new 3V CR123A lithium battery in the compartment. Note the positive and
negative polarity.
C
Lock the detector back on the bracket. Test if the battery is placed correctly by activating the test mode. (See step 6).
DISCLAIMER
This product is used as a warning device to aid the user in detecting for the presence of smoke. However, it remains
the responsibility of the end-user to prevent, detect and/or extinguish a (smoldering) fire or smoke from accumulating.
Therefore Trust cannot be held responsible or liable for any damages or injuries resulting from fire, smoke or heat or any
subsequent damages.
REPLACE SMOKE DETECTOR
Replace the smoke detector max. 10 years after the date of manufacture. The production date can be found on the
mounting plate of the smoke detector. (year-month-day)
8