Descargar Imprimir esta página

Trust ZPIR-8000 Manual Del Usuario página 4

Ocultar thumbs Ver también para ZPIR-8000:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
EN
ZPIR-8000 MOTION DETECTOR
COMPATIBILITY
The sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.
1. (RE)PLACE THE BATTERIES
A
Remove the battery cover from the sensor.
B
Place 2x AAA batteries (not included) in the sensor. Note the positive and negative polarity in the compartment. Close
the battery cover.
2. INDICATORS
The sensor contains a LED indicator (This is not a button) to show the status of the sensor. Please see below the meaning
of the different LED indications.
LED FUNCTION TABLE
Connection mode
Connected successfully
Sensor reset
Sensor triggered (When motion
is detected)
3. DOWNLOAD APP
To connect the sensor with a Z1 ZigBee bridge or ICS-2000/Smart Bridge, first get the App by scanning the QR code or go to
trust.com/zigbee and install it.
4. CONNECT SENSOR
A
In the App, select a room,press the + button and follow instructions. For manual set up of push-notifications go to the
rules tab, press the + button and select notification wizard.
4
LED will flash once per second for
approximately 1 min. (After 1 min the
LED will stop flashing)
LED will stop flashing (The App will
also indicate when the connection is
successful)
LED will flash fast (for 2 seconds)
LED will flash once

Publicidad

loading

Este manual también es adecuado para:

71170