Trust ZPIR-8000 Manual Del Usuario página 5

5. MOUNT THE SENSOR
A
Mount the arm of the sensor on a flat surface and secure it with the included screws.
B
1
Place the sensor on the mounting arm.
2
Secure the sensor by pulling it down on the mounting arm.
RESET SENSOR AND
ACTIVATE CONNECT MODE
Warning: This step will remove
the sensor from the Z1 ZigBee Bridge or the ICS-2000/Smart Bridge. To reset the sensor press the button in the hole at the
side of the sensor for approximately 5 sec with the included pin. The LED will flash fast to confirm the reset.
Activate connect mode: After resetting the sensor you can activate the connect mode by pressing the button for approx. 1
sec. The LED will flash for 1 minute to indicate the connection mode.
ZPIR-8000 MOTION DETECTOR
EN
5