Publicidad
Idiomas disponibles
Idiomas disponibles
B
Useful information
Troubleshooting
Fault
Light on, but motor
does not work
Light does not work,
motor does not work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood
inclines
NOTE
Any electrical repairs to this appliance must conform to
your local, state and federal laws. Please contact the service
centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when
opening the unit.
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Mains power cable is
loose or disconnected
One way valve and the
outlet are not tightly
sealed
Leakage from the
connection of chimney
and cover
Broken or faulty bulbs
The distance between
the cooker hood and the
gas top is too far
The fixing screw is not
tight enough
10
Solution
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable to power
outlet.
Switch power outlet on.
Take down the one way valve and seal
with sealant.
Take chimney down and seal.
Replace blubs as per this instruction.
Refit the cooker hood to the correct
distance.
Tighten the hanging screw and make
it horizontal.
EN
Publicidad
