König Electronic IR-URC33 Manual Del Uso página 3

same brand. Repeat the steps 3 to 6 until all the basic functions operate
correctly.
Note: Exit the setup mode by pressing the device button, or the setup mode is
automatically terminated if no button is pressed for 10 seconds.
B. Setup by Automatic Search
1. Switch on the device that you like to control. If it is a VCR insert a cassette.
2. Point the remote control at the device. Simultaneously press the SET and
Device buttons for three seconds. The LED should start flashing, that means
it is in Automatic Search now.
3. The OFF signal is automatically transmitted from the remote control to the
device (code scan). As soon as the device switches off, immediately press
any key (except SET key) to stop the Automatic Search.
4. Switch on the device again by pressing the "POWER" key. Check the
function of the other buttons on the remote control. If none of the buttons
function (i.e. the search cannot be stopped at the correct time) or the majority
of the buttons do not function correctly, restart the search (see steps 2 to 4)
to find a suitable code. If the majority of the buttons function correctly, setup
has been successful. Re-press the device button to save the code and to
terminate the setup mode.
Note: To automatically terminate the search, press any button (except the SET
button). The LED turns off and the search is terminated.
C. Setup by Manual Search
1. Switch on the device that you like to control. (If it is a VCR, please insert a
cassette).
2. Point the remote control at the device. Press and hold down the set button
and then press the device button. (For less than 3 seconds, otherwise Auto
search is started) Then release the two buttons.
3. The LED lights up and the remote is in setup mode.
4. Press the Power button (On/Off button) approx. every 1.5 seconds. (If
the device you are searching for is a VCR, DVD player, CD player, Tuner,
cassette recorder, etc., you can also press the play button.) The LED light
should start flashing, i.e. the device is in Manual Search Mode.
5. As soon as the device you are searching for switches off (or is reactive),
check whether the other buttons on the remote control function correctly (do
not press Power button, or else it will move to next code). If the majority of
the buttons does not function correctly, press the button approx. every 1.5
seconds to initiate the reactive code (manual search is continued, see steps
4 to 5). If the majority of the buttons on the remote control functions correctly,
save the code by pressing the Device button to terminate the manual search.
Note: The Manual Search is automatically terminated if no entry occurs during a
30 seconds period.
D. Setup by learning function
The learning function is used to extend the pre-programmed codes. A fully
functional original remote control is required for learning programming.
1. Press down and hold the Learn button and press the device (e.g. DVD) that
you want to learn-in, then release both pressed keys. The LED starts flashing
and then the remote control is in learning mode for DVD codes.
2. Press and release the target button which you want to learn in(e.g. POWER),
the LED lights up.
3. Point the original remote control to the receiver LED (the same as transmitter
LED). Ensure that both remotes are approx. 30mm apart and facing each
other.
4. Press and hold the source button on your original remote control until the
LED flashes 2 times and lights up for 2 seconds, and then flashes again. If
an error occurs, the LED flashes four times, lights up for two seconds and
then flashes again.
5. Repeat Step 2 to 4 to learn in more buttons.
3