Conceptronic C3USB2 Manual De Instrucciones página 4

ENGLISH
1. Package contents
•
One USB 2.0 HUB
•
One USB Cable
•
One Power Adapter DC 5V 1A
•
This Quick Installation Guide
•
Warranty card
2. Features
•
USB 2.0 compliant and USB 1.0/1.1 compliant
•
Plug and Play with USB Devices
•
All Downstream ports allows full speed and low speed operation
•
Support Self-Powered mode and Bus-Powered mode.
•
Each downstream port is equiped with OCD (Over Current Detection) and
OCP (Over Current Protection) functionality.
3. Overview
The USB Hub provides the interface between USB devices and the computer. The
Hub allows you to connect up to 3 USB devices to your USB HUB.
4. Hardware installation (all operating systems)
The USB Hub can work without AC/DC power supply, but it is strongly
recommended to use the power supply.
1. First of all, insert the plug of the power adapter into the power jack of the USB
Hub and connect the power supply into a wall outlet.
2. Connect the USB cable into the computer and USB Hub. The Hub will be
automatically found and installed in your Operating System, no drivers are
needed.
3. When the device is installed you can connect your USB devices to your USB
Hub. Depending on your USB device you might need to install a driver for that
USB device.
4