Publicidad
Idiomas disponibles
Idiomas disponibles
Model 2086
S T E P 0 3
With the help of another person, pick up the griddle body and
set it on its wheels.
Use one (1) shear pin and one (1) cotter pin to attach the upper propane tank
hanger to the upper bar of the left leg assembly.
TROUBLESHOOTING
Visit BLACKSTONEPRODUCTS.COM/SUPPORT for additional
troubleshooting.
Section 01
BAT TERY POWERED IGNITION
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
S T E P 0 4
Install the two (2)
control knobs by pushing them into
If you CAN ignite your griddle with a match
place in the OFF position. Insert one
(1) AA battery (not included) under
POSSIBLE CAUSES
the ignition button.
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
If you CAN NOT ignite your griddle with a match
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
Assembly Guide
| Owner's Manual
Troubleshooting
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
blackstoneproducts.com/support
07
Publicidad
