Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Specifications
Power Supply:
AC 100 V-240 V, 50/60 Hz
Volume:
90 dB
Backup Battery:
3.7 V 600 mAh lithium battery, 2.22 Wh
Static Current:
<13 mA
Alarm Current:
<100 mA
Radio Frequency:
915 MHz
Housing Material:
PC+ABS plastic
Operation Condition:
Temperature: 0 °C ~ +55 °C
Relative Humidity: < 80% (non-condensing)
Dimensions:
90 x 90 x 42.2 mm (Plug part excluded)
Industry Canada Notice
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
FCC STATEMENT
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
①
Increase the separation between the equipment and receiver.
②
Connect the equipment into an outlet on a circuit different from
③
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
④
help.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions : (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
EN
Publicidad
