Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove screws from Rear Guard and tilt wheel
(Figure 2).
2. Loosen motor nuts, and motor safeguards (located
above and below motor).
Figure 2: Removing Guard
1. Inspect your fan before each use. Check all wires and
extension cords, following the procedure outlined on
Page 1 (Safety Information).
Figure 4:
Capacitor Assembly
© 2018, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING
OR WHILE CONNECTED TO A POWER SOURCE
Belt Tightening / Replacement
Maintenance and Storage
2
3. Remove belt to replace, or adjust motor to tighten belt
(Figure 3).
Figure 3:
Adjusting Fan Belt
2. After use, always be sure fan's Power Switch is in the
OFF position before unplugging. Use cord wrap (see
page 4 Item #5) to keep cord off the ground when
transporting fan.
Bearings
Figure 5: Fan Shaft Assembly
High Capacity Barrel Fan User's Manual
Bearing E-clips
Publicidad
