Publicidad
Idiomas disponibles
Idiomas disponibles
A/ TRANSMITTER
The transmitter operates on power. Connect
the power adapter to the wall outlet.
B/ RECEIVER
1. Operation with battery supplied
The lithium polymer battery is already installed in the receiver. To replace the battery, unscrew the battery compartment cover
(22), and remove the battery.
2. Charge the battery with the AC adapter
When your receiver's battery runs down, use the mains power adaptor (included) to recharge it.
When the battery is fully charged, the red light will turn green.
NB. Prior to first use, charge the lithium polymer battery for at least three hours. It is recommended that the device be turned off
during the first charge.
NB. To ensure longer battery life, wait for the battery to fully discharge power before recharging.
Your transmitter and receiver are already connected and ready to communicate. This Babyphone can operate with different video
cameras (up to 4). To connect an additional video camera, follow the instructions below.
The transmitter and receiver are both equipped with a synchronisation button.
1. Turn on the receiver (hold down the power button (12) for 3 seconds) and the video camera to be connected (On/Off button
(1)).
2. Press and hold the synchronisation button on the receiver (21)
for 3 seconds. You will see the default message "Pairing ..." for
the already connected video camera. Press the receiver
synchronisation button a second time (21) to connect the video
camera or cameras you desire.
3. At the same time, use a pointed object to press and hold the
synchronisation of your video camera (8) for 5 seconds.
4. The two units are connected when the message «OK» appears.
5. If the "Fail" message appears, repeat the steps described
above.
12
Wait 10 minutes before using your babyphone.
RECEIVER CONNECTION TO THE TRANSMITTER
BABY MONITOR TOUCH SCREEN • Instructions for use
POWER SUPPLY
Pairing...
PAIR
1
2
3
4
PAIR
1
2
OK
3
4
PAIR
1
2
Fail
3
4
PAIR
1
2
Pairing...
3
4
Publicidad
