Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Special Mode Operation: Memory Functions
User Memory Settings
The Swash User 1 and User 2 memory
functions allow you to program your preferred
wash settings for rear, front, or strong wash
cycles for two users. These settings include
nozzle positioning, water pressure, water
temperature, seat temperature, and move
function. Follow the steps below to program
and use the memory function.
Programming User 1 Memory Function
1. Sit on the seat and select your wash cycle
(rear, front, strong). Adjust the nozzle
position, water pressure, water temperature,
seat temperature, and/or activate move
function, to your preference.
2. Press the Stop button.
3. Press User 1 for 2 seconds. A beep will
occur, and the yellow Deodorize LED
light on the remote will blink to confirm
programming is complete.
4. Repeat instructions for the next wash cycle
you want to program.
Programming User 2 Memory Function
1. Sit on the seat and select your wash cycle
(rear, front, strong). Adjust the nozzle
position, water pressure, water temperature,
seat temperature, and/or activate move
function, to your preference.
2. Press the Stop button.
3. Press User 2 for 2 seconds. A beep will
occur, and the yellow Deodorize LED button
on the remote will blink to confirm the
programming is complete.
4. Repeat instructions for the next wash cycle
you want to program.
Using User 1 and User 2 Memory Function
1. Sit on the seat and select User 1 or User 2.
The deodorize LED light will flash alerting
you that user memory is activated.
2. Press Rear, Front, or Strong Wash
button depending on which cycle was
programmed.
3. The preset nozzle positioning, water
pressure, water temperature, seat
temperature, and move function (if selected)
will be activated.
4. To stop user preset wash before the cycle
ends, press Stop.
5. To exit user preset, press the same user
button again and the deodorize LED light
will turn off. This will revert to the previous
settings.
NOTE: After leaving the seat without
manually exiting, the seat will
automatically revert to the previous
settings.
21
Publicidad
