Before Using For The First Time; Processing Capacity Chart; Operating Instructions For The 24 Oz Personal Cup - Bella IM_R4 Manual De Instrucciones

Before Using for the First Time

Carefully unpack the 2 in 1 Emulsifying Blender and remove all packaging materials.
Check the contents to ensure that all attachments and accessories are present (see Figure 1), and have
been received in good condition.
1. Handle the blending blade by its collar only.
WARNING: Do not touch blades. Blade attachments are very sharp. Use extreme care when
handling. Failure to do so can result in personal injury.
2. Wash the jar, cup, blade and lip ring in warm soapy water. Rinse and dry thoroughly.
3. The motor base may be wiped with a damp cloth.
WARNING: DO NOT IMMERSE THE MOTOR BASE IN WATER.

Processing Capacity Chart

Description Size
Blender Jar Large
Cup Tall

Operating Instructions for the 24 oz Personal Cup

Place the motor base on a at, clean, dry countertop or table.
1. Make sure the unit is unplugged.
2. Place the food to be processed into the cup. The cup has a maximal capacity of 24 oz. (3 cups).
3. To assemble for blending, using the blade's collar to handle, place the blade into the cup (see Figure 2).
IMPORTANT: Check to make sure the lip ring is not attached to the cup before assembling the blade.
If it is, simply lift off to remove.
IMPORTANT: In the base of the blade's collar, there is a plastic gasket seal that creates an airtight
t with the cup. After dishwashing and before each use, always check to make sure the gasket is
properly in place, as the heat from some dishwashers may cause the gasket to become loose.
WARNING: Never operate the 2 in 1 Emulsifying Blender when the processing cup is empty.
WARNING: Never over ll the processing cup. Do not exceed the MAX line.
4. Hold the cup rmly in one hand. Use the other hand to tighten the blade assembly by turning
the blade collar clockwise until snug (see Figure 2).
5. Plug the power cord into a 120 V AC electrical outlet.
6. Invert the processing cup with the blade assembly in place. Insert the blade collar into the motor
base, tting the tabs into the slots on the motor base (see Figure 3).
NOTE: The 2 in 1 Emulsifying Blender will not operate unless the 3 locking tabs on the blade collar
are properly tted into the 3 slots on the motor base.
7. To process, turn the processing cup clockwise into the motor base and press down on the top of
the cup until locked in place. The blender will operate.
WARNING: Do not operate the motor continuously for more than 1 minute at a time.
Allow the motor to rest for 3 minutes before continuing.
8. When processing is completed, turn the cup counter clockwise in the base and lift to remove
the cup with its blade assembly.
9. Invert the cup with its blade assembly. Hold the cup
the blade collar counter-clockwise and remove the blade from the processing cup.
10. Add the lip ring to drink fresh juice, blended drinks or smoothies immediately.
Press down to fasten the lip ring to the blending cup.
11. Unplug the 2 in 1 Emulsifying Blender when not in use and before cleaning.
Figure 2
SO-313506_14588_BELLA 2in1 Blender IM_R4.indd 5
MAX Process
4 cups (32 oz.)
3 cups (24 oz.)
Figure 3
5
rmly in one hand. Use the other hand to turn
2016-06-06 11:18 AM