Publicidad
Idiomas disponibles
Idiomas disponibles
6. Place the broil burner on the broil burner orifice hood.
Insert the broil burner ceramic igniter in the hole in the
rear of the oven.
7. Replace the flame spreader with all 4 tabs facing up
and the notches toward the rear of the oven.
8. Position the broil burner against the top of the oven
and attach it with 1 screw.
9. Replace the storage drawer. See the "Remove/Replace
Drawer" section.
10.
Replace the oven door. See the "Oven Door" section.
11.
Replace the oven racks.
Complete Installation (Propane Gas to Natural Gas)
1. Refer to the "Make Gas Connection" section for proper
connection of the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition and operation.
3. Refer to the "Adjust Flame Height" section for burner flame
adjustments.
IMPORTANT: You may have to adjust the low setting
for each cooktop burner.
Checking for proper cooktop, bake, and broil burner
flame is very important. Natural gas flames do not
have yellow tips.
4. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete
this procedure.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner flames. The cooktop "low"
burner flame should be a steady blue flame approximately
1
/
" (0.64 cm) high. Propane gas flames have a slightly yellow
4
tip.
A
B
A. Low flame
B. High flame
To Adjust Standard Burner:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
20
If the "Low" Flame Needs to Be Adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
flat-blade screwdriver to turn the screw located in the
center of the control knob stem until the flame is the proper
size. Turning the screw clockwise will increase the flame
size and counterclockwise will decrease the flame size.
A
A. Control knob stem
B. Screwdriver
C. Pliers
3. Replace the control knob.
4. Test the flame by turning the control from the low position
to the high position, checking the flame at each setting.
5. Repeat the previous steps for each burner.
To Adjust Double Burner (on some models):
1. Light burner and turn to lowest setting where both inner
and outer burners are lit.
2. Remove the control knob.
3. Insert a
/
" (3 mm) flat-blade screwdriver into the
1
8
adjustment locations shown in the following illustration
and engage the slotted screw. Turn the screw until the
flame is the proper size. Turning the screw clockwise
will increase the flame size and counterclockwise will
decrease the flame size.
A
A. Control knob stem
B. Screwdriver
C. Pliers
4. Replace the control knob.
5. Test the flame by turning the control from the low position
to the high position, checking the flame at each setting.
Check Operation of Oven Bake Burner
Refer to the Use & Care Guide for proper operation of the
oven controls.
B
C
B
C
Publicidad
