Publicidad
Idiomas disponibles
Idiomas disponibles
Operation—Power Tool (cont'd)
Overheat Warning Lamp (2)
Off
Flashing: Overheat
(normal operation)
Indicates operation has been
halted due to battery overheating.
The overheating protection feature halts driver
operation to protect the battery pack in the event of
overheating. The overheat warning lamp on the control
panel flashes when this feature is active.
• If the overheating protection feature activates, allow
the driver to cool thoroughly (at least 30 minutes).
The driver is ready for use when the overheat
warning lamp goes out.
• Avoid using the driver in a way that causes
the overheating protection feature to activate
repeatedly.
• If the tool is operated continuously under high-load
conditions or if it is used in hot-temperature condi-
tions (such as during summer), the overheating
protection feature may activate frequently.
Battery Low Warning Lamp (3)
Off
(normal operation)
Excessive (complete) discharging of lithium-ion
batteries shortens their service life dramatically. The
driver includes a battery protection feature designed to
prevent excessive discharging of the battery pack.
The battery protection feature activates immediately
before the battery loses its charge, causing the battery
low warning lamp to flash
If you notice the battery low warning lamp flashing,
charge the battery pack immediately.
Recommended Grip
Use the grip to hold and operate the driver with one
hand. If the job requires additional force, push against
the rear end of the driver with your other hand.
13
LRH-288
Flashing (no charge)
Battery protection feature active.
Publicidad
