Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
(Continued)
• Save all instructions
I
Tilling Tips
The key to successful tilling is to begin with a shallow cut
on the first pass, and then work an inch or two deeper on
each successive pass .
• Tilling depth will vary with ground conditions .
• When beginning to till in unbroken ground or in
extremely hard soil, set the pin in the highest hole of the
depth regulator (follow instructions under Tilling
section) . This will allow for shallow tilling . With the depth
regulator in this position, make several light passes over
the area to be tilled . Reset for deeper depths with
successive passes .
• If tiller jumps or skids uncontrollably, lower the depth
regulator by placing the pin in a higher hole . This will
allow for shallower tilling . Hold firmly to the handlebars
to control sudden lurches .
• If weeds, tall grasses, vines, or other materials clog or
jam the tines, reverse the tiller to unwind vegetation .
J
Cultivating Tips
If you plan to use your tiller for cultivating:
• Plant rows on 20" - 22" centers for ease of turning .
• Set the depth regulator lever with the detent pin in one
of the higher holes . This will allow for shallow cultivation
necessary to turn over weeds, and break up and aerate
the soil .
Questions? Call Toll Free at 1-800-737-2112
WARNING
Immediately release the drive control levers if the tines jam
or you strike a foreign object . With drive control levers in
neutral position, stop the engine . Disengage the spark plug
wire . When tines have stopped, remove foreign objects and
check for damage .
WARNING
Extreme caution must be taken in selecting tilling depth .
If you attempt to till too deeply for soil conditions (with the
depth regulator lever in too high a position) loss of control
could result .
If removing material from the tines by hand, stop engine and
remove spark plug wire first.
Copyright © 2018 MAT Engine Technologies, LLC
14
Publicidad
