Assembly Instructions - Gardenline 43537 Manual Del Usuario

2 Person Swing
STEP 4: Lining up the holes in the Arms (D) with the holes in the side tubes of
the Back and Seat Frame (F, G). Insert Bolt (Q) from inside through the arm holes,
Plastic Washer (X), side bar on the Back and Seat Assembly, Washer (V) and Nut
(U). Don't tighten completely. See Fig.4. Repeat this step on the other side. Then
securely tighten the Bolts and Nuts and cover with Caps (W, Y).
7
cs@discoverhomeproducts.com
USA

Assembly Instructions

V U W
AFTER SALES SUPPORT
1855 965 5310
USA
2 Person Swing
STEP 5: Attach the Hanging Pipe (E) to one side of the Armrest of the previously
assembled Back & Seat (F&G) with Bolt (S), Bolt Cap (Y), Washer (V), Nut (U)
and Nut Cap (W) as shown in Fig.5. Repeat using same parts and steps to attach
the Hinging Pipe to the opposing side.
STEP 6: Attach the Spring Hook (J) to the end of Hanging Pipe (E) and attach the
hook to the Leg structure assembled by Step 3 as shown in Fig.6.
AFTER SALES SUPPORT
1855 965 5310
USA
USA
Assembly Instructions
V U W
8
cs@discoverhomeproducts.com