Publicidad
11. SAFETY RECOMMENDATIONS
Bending and combined (bending/cutting) machines, be used by trained people or people familiarized with
their operation.
•
Before starting up the machine please read the instructions and make sure safety norms are
respected. Learn how to stop the machine in a fast and safe way.
•
Place the machine on a plane surface. Connect the machine to the electricity only when you are sure
of its stability.
•
Start the machine only when you have mounted the safety guards that come with the machine.
•
It is recommended to use safety glasses, safety boots, gloves etc. Please always use approved
materials.
•
Always use Individual Protection Equipment (IPE) in accordance with the type of work you are
effectuating.
•
Prohibit strangers to access the place of work of the machine.
•
Work clothes are not supposed to have loose articles that can cling into movable parts of the
machine.
•
When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
•
Always keep protection elements and the safety guards in their correct positions.
•
Attention: Before placing the bolts, mandrills and the bending squares, check the direction of
rotation of the bending plate. You can then install the suitable accessories for the type of work you
want to make.
•
The damaged electrical cables should be urgently replaced.
•
Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor
electrical elements of the machine while the engine is on.
•
Never use the machine for purposes other than those it has been designed for.
VERY IMPORTANT: Always use earth plug before starting-up the machine.
• Use normalised cables
• Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the machine.
• Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp edges.
Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the machine.
• Do not use high pressure water to clean circuits or electrical elements.
ATTENTION: You are to follow all safety recommendations mentioned in the present user manual and
comply with all labour risks prevention norms in every location.
SIMA, S.A. is not responsible for the consequences possibly generated but the inadequate use of the
bending or the combined (bending/cutting) machine.
14
ENGLISH
Publicidad
