LG WF-T1402TP Manual Del Propietário página 17

3
The pulsator rotates for
8 seconds to detect the
laundry load.
Then the WATER LEVEL
and the amount of
Detergent to be used
will be shown and
water will be supplied.
4
4
4
4
Close the lid
5
Water will be When the wash
supplied for 2 program ends, the
minutes after the buzzer will ring
start of the wash to for 10 seconds
supplement the before the Power
water the laundry goes off
has absorbed. automatically.
6
6
6
6
Finish
If water is already in the tub, or putting
6
wet laundry into the tub before starting
will increase the WATER LEVEL.
With lightweight bulky loads, WATER
LEVEL can be set low.
Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
7
7
When setting the WATER LEVEL
7
manually, do not set to Medium to
prevent damage to laundry.
Washing with HOT water may damage
the laundry (Water is set to cold
automatically). Ensure that the load is
under 2kg.
In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and clothing
may still contain some water. This is
normal.
Before starting to wash, make sure that
7
the laundry is washable.
Washing with HOT water may damage
the laundry (Water is set to COLD
automatically).
Ensure that the load is under 2kg.
Caution & Note
17