Publicidad
J
x 4
5/8"
FIG. 5
5. Optional: Complete this step if you wish to conceal the gap between the two doors.
The Door Skirt (I) may be attached to either the left or right door. This will be the door you
close first. With the door laying face down, measure in 5/8" from the outer edge and draw a
line. Lay the inner edge of the Door Skirt (I) on the line, with the bottom edge flush with the
bottom of the door. Attach the Skirt to the door with four Screws (J) through the predrilled
holes in the Skirt.
Hinge
Arm
D
2
FIG. 6A
6. To attach the doors to the unit, slide the hinge arms (B) onto the Hinge Plates (D) as shown in
FIGURE 6A. Tighten the screw marked '2' in FIGURE 6A to fasten the hinge. The door may
need to be adjusted so that all the spaces between the door and the unit sides are equal. To
adjust, follow instructions in FIGURE 6B.
J
DOOR (A)
3
2
B
3
J
J
1
FIG. 6B
J
Side adjustment 4mm (5/32")
To move the door towards the side
panel, loosen screw '1' and tighten
screw '2'. To move the door away
from the side panel, loosen screw '2'
and tighten screw '1'
Depth Adjustment 4mm (5/32")
Loosen screw '2' (Just one turn),
adjust door to desired position,
re-tighten screw.
Height Adjustment 4mm (5/32")
Loosen screw '3', adjust door to
desired position, re-tighten screw.
219W, 220W, 227W, 228W — Page 5
Publicidad
