Publicidad
J
x 2
FOR BASE UNITS ONLY:
7. If no adjustable shelf is to be used behind the doors on a base unit, a Door Stop (K) must be
used. Hold the Door Stop (K) against the back of the molding on the top shelf of the base unit.
Center it and draw a pencil mark across the back of the stop on the underside of the top shelf
on the base unit. Slide the Door Stop back until the mark is visible in the slots. Attach the stop
to the underside of the base unit with Screws (J) on the index line you just drew. The slots
allow for finer adjustment so that the door faces are in line.
L
x 2
8. Attach a Pad (L) to the back of each door where it comes in contact with the door stop or
adjustable shelf.
IMPORTANT:
9. When installing any door kit to a base or hutch unit, you must install a Furniture Tipping
Restraint. This hardware can be found in either the base or the hutch's hardware kit,
depending on furniture confi guration. Follow all directions for proper installation.
Page 6 — 219W, 220W, 227W, 228W
FIG. 7A
J
FIG. 7B
Publicidad
