Publicidad
Idiomas disponibles
Idiomas disponibles
Attention: The Axxess Updater App can also be used to program the following (3) sub-sections as
well, pending that the interface has been initialized and programmed.
Changing radio type
If the LED flashes do not match the radio you have connected, you must manually program
the AX-GMCL2-SWC to tell it what radio it is connected to.
1. After (3) seconds of turning the key on, press and hold the Volume-Down button on the
steering wheel until the L.E.D. in the AX-GMCL2-SWC goes solid.
2. Release the Volume-Down button; the L.E.D. will go out indicating we are now in Changing
Radio Type mode.
3. Refer to the Radio Legend to know which radio number you would like to have
programmed.
4. Press and hold the Volume-Up button until the L.E.D. goes solid, and then release. Repeat
this step for the desired radio number you have selected.
5. Once the desired radio number has been selected, press and hold the Volume-Down button
on the steering wheel until the L.E.D. goes solid. The L.E.D. will remain on for about (3)
seconds while it stores the new radio information.
6. Once the L.E.D. goes off, the Changing Radio Type mode will then end. You can now test the
steering control wheel controls.
Note: If at any time the user fails to press any button for a period longer than (10) seconds,
this process will abort.
10
STEERING WHEEL CONTROL SETTINGS
(CONT)
Radio legend
1. Eclipse (Type 1)
7. Alpine
2. Kenwood
8. Visteon
3. Clarion (Type 1)
9. Valor
4. Sony/Dual
10. Clarion (Type 2)
5. JVC
11. Metra OE
6. Pioneer/Jensen
12. Eclipse (Type 2)
Remapping the steering wheel control buttons
Let's say you have AX-GMCL2-SWC initialized and you want to change the button assignment
for the steering wheel control buttons. For example, you would like Seek-Up to become
Mute. Follow the steps below to remap the steering wheel control buttons:
1. Ensure the AX-GMCL2-SWC is visible so you can see the L.E.D. flashes to confirm button
recognition.
Tip: Turning the radio off is recommended.
2. Within the first twenty seconds of turning the ignition on, press and hold the Volume-Up
button on the steering wheel until the L.E.D. goes solid.
3. Release the Volume-Up button, the L.E.D. will then go out; The Volume-Up button has now
been programmed.
4. Follow the list in the Button Assignment Legend to reference the order in which the steering
wheel control buttons need to be programmed.
13. LG
14. Parrot
15. XITE
16. Philips
17. TBD
18. JBL
Continued on the next page
Publicidad
