Publicidad
Idiomas disponibles
Idiomas disponibles
NOTES:
When reaching a certain comfortable temperature, slowly turn the Manual Temperature
Control Knob counter-clockwise until a "click" sound heard(about half-round of the knob
circle), at this time the unit will not be cut off when meeting overheat, and the unit will not
be turned on automatically after cooling down. So keep the knob on the position of the
latter half-round of the knob circle, if set it to front half-round knob circle, modes setting
also can not be used. If setting to "-" position, the unit will be turned off.
6. Select the proper setting to accommodate your comfort level with the Power Knob.
The Power/Mode Setting Knob is equipped with three(3) mode settings, "I" (750W), "II"
(1500W) and FAN( Natural Wind) . You can select the proper setting to accommodate
your comfort level with this Knob.
7. After heating, turn Power/Mode Setting Knob to "FAN" position to cool down the heater,
then turn to "OFF" position and unplug the heater.
OVERHEAT PROTECTION
1. A thermal overload protector is built in at the top of the heating panel, if the heater is
obstructed or blocked at front panel and rear ventilation panel by the curtain, drape or
cotton sheet etc., the thermal overload protector activates to prevent overheat.
2. When the internal temperature of the heater reaches up to 70 Celsius which may cause
fire hazard, the heater will be shut off automatically. It can ONLY resume operation when
the user resets the unit.
To Reset Heater:
1. Unplug the heater and wait about 15 minutes until the heater cooling down.
2. After the heater has cooled down, plug the unit into a 110-120V electrical outlet again
and follow the operation instructions described in this manual.
TRIP-OVER PROTECTION
A tip-over switch is placed at the bottom of the heater, when the heater is taken away or
knocked over by pets or human, the heater will be shut off automatically to prevent burning
combustible materials.
6
+
Publicidad
