Publicidad
Idiomas disponibles
Idiomas disponibles
33 electrolux installation
Installation
Unpacking
01. Bring the appliance close to the installation place.
02. Be careful when unpacking and installing the appliance. Sharp edges might
cause accidents.
03. Packing material is recyclable. Separate plastics, from cartoons and foams
to send to each recycling company.
Provision for ventilation
The cooktop should not be installed in a room with a volume of less than 20 m³.
If it is installed in a room of volume less than 5 m³ an air vent of effective area of
110 cm² is required. If it is installed in a room of volume between 5 m³ and 10
m³ an air vent of effective area of 50 cm² is required, while if the volume
exceeds 11 m³ no air vent is required. However, if the room has a door which
opens directly to the outside no air vent is required even if the volume is
between 5 m³ and 11 m³. If there are other fuel burning appliances in the same
room, which should be consulted to determine the requisite air vent
requirements.
Location
The cooktop may be located in a kitchen, a kitchen/diner or bed sitting room,
but not in a bathroom, shower room or garage. Before making the cut out in the
worktop ensures that there is a minimum distance of 55 mm between the rear
edge of the cooktop and the wall. A minimum distance of 100 mm must be left
between the side edges of the cooktop and any adjacent cabinets or walls. The
minimum distance combustible material can be fitted above the cooktop in line
with the edges of the cooktop is 400 mm. If it is fitted below 400 mm a space of
50 mm must be allowed from the edges of the cooktop. The minimum distance
combustible material can be fitted directly above the cooktop is 700 mm.
The use of a gas cooking appliance results in the production of heat and
moisture in the room in which it is installed. Ensure that the kitchen is well
ventilated: keep natural ventilation holes open or install a mechanical ventilation
device.
Prolonged intensive use of the appliance may call for additional ventilation, for
example opening of a window, or more effective ventilation, for example
increasing the level of mechanical ventilation where present.
A
B
(*)
*air inlet minimum section: 100cm²
When the cooktop is first installed
Once the cooktop has been installed, it
is important to remove any protective
materials, which were put on in the
factory.
Any gas installation must be carried out
by a qualified person. The manufacturer
will not accept liability, should the above
instructions or any of the other safety
instructions incorporated in this manual
be ignored.
On the end of the shaft, which includes
the GJ 1/2" threaded elbow, adjustment
is fixed so that the washer is fitted
between the components as shown in
the diagram. Screw the parts together
without using excessive force.
The cooktop must be installed by a qualified person to the relevant Gas
Standards. Please, ensure that, once the cooktop is installed, it is easily
accessible for the engineer in the event of a breakdown.
installation electrolux 34
D
(*)
(*)
End of shaft
with ½ BSP
male thread
Washer
Connector nut
Barb connector
for hose
Publicidad
