Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
(Continued)
• Save all instructions
B
Assembly Instructions
The tiller comes fully assembled except for a few parts.
The following instructions will help you complete the tiller
assembly.
INSTALL THE WHEELS
(See Figure 2)
1. Assure cupped washer is installed onto wheel axle.
2. The tiller wheels are directional. For best performance
install the wheels with the tire thread facing the direction
as shown.
3. Slide the wheel hub onto the wheel axle.
4. Align the wheel hub hole with the hole in the axle and
insert the locking pin.
5. Rotate the locking pin ring to lock the pin in position.
INSTALL THE DEPTH REGULATOR
1. Insert the depth regulator into the bottom of the depth
regulator bracket.
2. Insert the pin through the bracket and lever.
Questions? Call Toll Free at 1-800-737-2112
(See Figure 3)
If you need assistance or find any parts missing,
CALL TOLL FREE: 1-800-737-2112.
Wheel lock pin in tiller operating position
(wheel hub and axle holes)
Copyright © 2016 MAT Engine Technologies, LLC
8
FRONT
Figure 2
Pin
Depth Regulator
Bracket
Depth Regulator
Lever
Figure 3
Publicidad
