Torin BIG RED T42002A Manual Del Propietário página 3

GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may
result in serious injury.
CAUTION: Do not allow persons to operate or assemble this jack until they have read this manual and
have developed a thorough understanding of how the jack works.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions or situations that could occur. It must be understood by the operator
that common sense and caution are factors that cannot be built into this equipment, but must be supplied
by the operator.
EQUIPMENT USE AND CARE
• Do not modify the jack stands in any way. Unauthorized modification may impair the function and/or safety
and could affect the life of the equipment. There are specific applications for which the jack stands were
designed.
• Always check of damaged or worn out parts before using the jack stands. Broken parts will affect the
jack stands operation. Replace or repair damaged or worn parts immediately.
• Store idle jack stands. When jack stands are not in use, store them in a secure place out of the reach of
children. Inspect it for good working condition prior to storage and before re-use.
WARNING! NEVER use automotive jack stands to support both ends, or one side of a vehicle!
WARNING! NEVER use on jack stands on a lawn mower or lawn tractor.
Use only 1 pair per vehicle. Rated capacity is per pair only!
INSPECTION
• Inspect the equipment carefully before each use. Ensure the equipment is not damaged, excessively worn,
or missing parts.
• Do not use if components are bent, broken or cracked.
• Using equipment that is not in good clean working condition may cause serious injury.
• Inspect the work area before each use. Make sure it is free and clear of any potential hazards.
DO NOT OPERATE OR REPAIR THIS EQUIPMENT WITHOUT READING THIS MANUAL.
To maintain the equipment and user safety, the responsibility of the owner is to read and follow these
instructions.
• Inspect the equipment for proper operation and function.
• Keep instructions readily available for equipment operators.
• Make certain all equipment operators are properly trained; understand how to safely and correctly operate
the unit.
• Allow unit operation only with all parts in place and operating properly.
• Use only genuine replacement parts.
• Service and maintain the unit only with authorized or approved replacement parts; negligence will make the
equipment unsafe for use and void the warranty.
• Carefully inspect the unit on a regular basis and perform all maintenance as required.
• Store these instructions in the handle of your equipment.
• Keep all decals on the unit clean and visible.
GENERAL SAFETY RULES
IMPORTANT SAFETY CONSIDERATIONS
3