Renegade REN1000S Mk3 Manual De Uso página 11

FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) POWER-LED and PROTECT-LED
(2) Connector for the included bass level remote controller
(3) Bass EQ controller
(4) Subsonic filter controller
(5) Lowpass filter controller
(6) Gain evel controller
(7) Audio signal outputs to run additional amplifiers
(8) Audio signal inputs
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the headunit or the electrical antenna
(7) Fuse
1-CHANNEL OPERATION MONO 1 SUBWOOFER (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the headunit to drive a subwoofer, connect
the following setup:
(1) To the headunit, line output left or subwoofer output
(2) To the headunit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer (2 - 8 Ω)
1-CHANNEL OPERATION MONO 2 SUBWOOFERS (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the headunit to drive two subwoofers,
connect the following setup:
(1) To the headunit, line output rear left or subwoofer output
(2) To the headunit, line output rear right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer 1 (4 - 8 Ω)
(5) Subwoofer 2 (4 - 8 Ω)
IMPORTANT!
Always observe the correct polarity of all connections!
11