Bimar HP120 Manual De Instrucciones página 9

• The fan heaters gets hot when in use. Only touch the plastic handle and
knobs. Avoid touching the grid since it becomes very hot. Do not insert
fingers and/or any object through the front grid, in order to prevent
abrasions, electric shocks or damage to the appliance.
• The grille does not provide complete protection to children or to people with
reduced physical, sensory or mental capacity.
WARNING!
- Parts of this product can become hot and cause burns. Special care
should be taken in the presence of children and vulnerable people.
- when using electrical appliances, always adhere to basic safety precautions
to prevent the risk of fire, electric shocks and physical injury.
- Do not use this appliance in a room with an area of less than 4m².
• The appliance can be used by children over 8 and by people whose physical,
mental or emotional capacity is limited or compromised, or who lack the
appropriate experience or knowledge, only if they are supervised after
receiving instructions about safe use of the appliance and they understand the
hazards. Children must not play with the appliance. Cleaning and
maintenance that must be carried out by the user must not be done by
children unless they are supervised.
• Children younger than 3 years of age must be kept away from the appliance
unless they are being constantly supervised. Children between the ages of 3
and 8 years should only turn on / off the appliance as long as it has been
placed or installed in its normal operating position, and as long as they are
supervised or receive instructions concerning the safe use of the appliance
and understand the hazards involved. Children between the ages of 3 and 8
years should not plug it in, adjust or clean the appliance or perform user
maintenance.
• Make sure the fan heater does not come into contact with water or any other
liquid. If water or any other liquid comes into contact with the appliance, first
turn off the power by switching it off at the distribution board, and only then
remove the plug from the socket. Carefully dry both the plug and the socket
9