Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Brush Or Pad (BOOST Machine)
To install the brush or pad on the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Press on a brush or pad, under the fl ex plates.
See fi gure 10.
NOTE: When using a black pad, position pad on head. Lower head
and operate momentarily to affi x pad to pad driver (if you have
diffi culty, position pad on fl oor and lower head then operate.)
How To Remove The Brush Or Pad (BOOST Machine)
To remove the brush or pad from the machine, follow this procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine and pull downward on the brush or
pad until it releases from the fl ex plates. See fi gure 11.
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
®
ENGLISH
Figure 10
Figure 11
®
EN
FORM NO. 56091125 - 13 -
Publicidad
