Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
EN
PROCEDURES FOR TRANSPORTING
How To Put The Machine In A Van Or Truck
How To Remove The Machine From A Van Or Truck
WARNING:
The machine is heavy. Make sure you use two able persons to assist
the machine in climbing the ramp.
1. Make sure the loading ramp is at least eight (8) feet long, and strong enough to support the machine.
2. Make sure the ramp is clean and dry.
3. Put the ramp in position.
4. Remove squeegee assembly.
5. Remove brush housing, pad drivers or brushes if transporting disc machine.
6. Turn key switch "ON".
7. Align the machine on a level surface, ten (10) feet in front of the ramp.
8. Put the traverse speed switch in the "HI" position.
9. Press one or both forward switches (must press both switches for model 56383986).
10. Push the machine to the top of the ramp.
11. Turn the key switch "OFF".
12. Fasten the machine to the vehicle.
1.
Make sure there are no obstructions in the area.
2.
Make sure the unloading ramp is at least eight (8) feet long and strong enough to support the machine.
3.
Make sure the ramp is clean and dry.
4.
Put the ramp in position.
5.
Unfasten the machine.
WARNING:
The machine is heavy. Make sure you use two able persons to assist in
moving the machine down the ramp.
6.
Turn the key switch "ON".
7.
Carefully and slowly, drive the machine to the top of the ramp by pressing and holding either of the forward switches and the
reverse switch.
8.
Put the traverse speed switch in the mid range speed setting. As the machine begins to travel down the ramp, maintain a slow
downward speed by pressing either of the forward switches.
9.
Replace squeegee assembly and other removed components, after the machine is unloaded and ready to use.
-6- FORM NO. 56091125
Clarke
revised 9/2014
®
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
®
Publicidad
