Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Symptom
Remedy
Phone sound quality
• Reduce the distance between the unit and the Bluetooth
is poor.
device.
• Move the car to a place where you can get a better
signal reception.
Sound is being
• Reduce the distance between the unit and the Bluetooth
interrupted or skipped
audio player.
during playback of a
• Turn off, then turn on the unit and try to connect again.
Bluetooth audio player.
• Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth
• Check whether the connected Bluetooth audio player
audio player cannot be
supports Audio/Video Remote Control Profile (AVRCP).
controlled.
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT"
The unit is preparing to use the Bluetooth function. If
the message does not disappear, turn off and turn on
the unit, then connect the device again.
"NOT SUPPORT"
The connected phone does not support Voice
Recognition feature.
"ERROR"
Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"H/W ERROR"
Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service
center.
If you have any troubles, try the following:
1
Check TROUBLESHOOTING
2
Reset the unit ( 3)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: <http://www.jvc.com>
INSTALLATION/CONNECTION
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of
the speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the
speakers. ( 23)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
battery.
2 Connect the wires properly.
See Wiring connection. ( 35, 36)
3 Install the unit to your car.
See Installing the unit (in-dash mounting). ( 34)
4 Connect the
terminal of the car battery.
5 Press
to turn on the power.
6 Detach the faceplate and reset the unit. ( 3)
terminal of the car
33
ENGLISH
Publicidad
