Ryobi RY404012 Manual Del Operador página 8

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Blower
Blower Tube
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
ASSEMBLY
Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
INSTALLING THE BLOWER TUBE
See Figure 2.
 With the logo area facing up, slide the blower tube over
the outlet on the blower housing.
 Press down on the tab on the blower housing outlet.
 Push tube on the blower housing outlet until tab
locks into place through the slot in the blower tube.
NOTICE:
When correctly assembled, the tube is difficult to sepa-
rate. If it can easily be removed, the tube is not locked.
Check that the tab and slot are aligned and push firmly
until the tube locks securely into place. If the tube is not
in the locked position, it can separate during blower
operation.
 To remove the blower tube, push tab down and slide tube
off.
OPERATION
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
6 — English
WARNING:
WARNING:
WARNING: