Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION :
DO NOT USE POWER TOOLS TO DRIVE SCREWS INTO
WOOD TOPS. HAND TIGHTEN SCREWS ONLY .
TIGHTEN SCREWS SNUG, BUT DO NOT OVER-
TIGHTEN, CAUSING SCREWS TO STRIP IN WOOD.
1.
Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
Align U-Support (#7) and U-Leg (#2) on Table Top as
2.
shown in Figure 1. Note: "U" Leg is Larger and
wider than U-Support. The U-Leg should be
installed on the end of the table half with the
end stripe on top side.
3.
Put plastic caps #13 on the end of U-leg #2.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
If you want to see a video on how to position the U-Clips go to:
http://www.escaladesports.com/customer-service/videos.html
4. Align the holes in the Large U-clips #3 with pilot holes in
table top assembly and secure with twenty four screws #20
as shown. All four holes in each U-Clip must align with four
pilot holes in top.
IMPORTANT:
Be sure that slot in the six U-clips #3 all face the same
direction (toward the middle of the table with the U-
support) as shown.
3
This end is the middle of the table
and has no stripe or pilot holes.
Figure 1
Table Top
13
Plastic
Cap
Stripe on End
U-Leg
This end will be the
middle of the table when
completely assembled.
20
3
3
3
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
2
The middle of the table is
the end that does not have
the stripe on top.
1
7
U-support
2
All screws shown
are (#20) sheet
metal screws.
3
3
13
Plastic
Cap
3
7
U-support
2
U-Leg
Figure 2
Publicidad
