Publicidad
Idiomas disponibles
Idiomas disponibles
8.
Screw left hand hinge brackets #6 to table top follow-
ing these steps:
A. Push U-leg #2 and hinge assembly flat against
top. See Figure 5.
B. Place a spacer that is about 1/16" thick between
hinge legs. Suggestion: either a nickel or a quarter
is an ideal spacer . See Figure 6.
C. With hinge bracket, hinge and leg flat against table
top and spacer between hinge legs, screw bracket
to table with five #20 screws. See Figure 6.
D . Open leg and lock leg hinge. See Figure 7. Re-
move spacer that you used between hinge legs.
9.
Repeat step 8 to attach right hand hinge bracket to
table.
Lock Hinge
27 (RH)
20
Figure 8
Figure 7
Pull T o
U-Support
7
2
U-Leg
Hinge
Bracket and Leg
flat against table
20
10a. Lay out rails #25 and 26, as shown in Figure 8, around edges
of table top.
10b. Slide
Right
#27 and
the Side Rails #25 as shown.
11. Line up holes in rails with pilot holes in top and secure using
eighteen screws #20. See Figure 8.
12. Lay Corner Caps #22 on table as shown in Figure 9. If Corner
Cap sticks above table top surface of table, flip over so shorter
distance is against edge. Secure to bottom of table with three
screws #24.
This end will be the
middle of the table when
completely assembled.
e r
n g
L o
4
Figure 5
6
2
U-Leg
2
Hinge
Spacer between
hinge legs
U-Leg
Left
Vinyl End #28 Caps onto the ends of
NOTE:
This smaller Corner
included in the hardware kit is
not used for this table, please
discard it. Use Corner Protector
shown in Figure 8 &9.
e
n c
s t a
24
D i
Figure 6
Protector
Figure 9
Publicidad
