Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 14
T op View
Name Panel #5
Safety Latch #8
(Flange extends over
Name Panel #5)
CAUTION:
23. Choose a name panel #5 on either side of the table and install
one safety latch #8 into the right-hand hole on that name panel
as shown in Figures 14 & 15. Use one screw #10 one washer
#17 and one hex nut #16. NOTE: Flange on safety latch
must extend over top of name panel as shown in Figure 14.
Safety latch must pivot freely.
24. Go to the other side of the table and install the second safety latch
into the right-hand hole on the other name panel #5. NOTE:
Safety latches must be attached diagonally across from
each other. (See Figure 15).
16
5
17
SAFETY
LATCH
#8
DO NOT OVERTIGHTEN
10
SAFETY LATCHES #8.
THEY MUST PIVOT FREELY!
INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
8
7
Figure 15
T op View Of T able
Safety Latch #8
(in right-hand hole)
Name Panel #5
Name Panel #5
Attach safety latches #8
Attach safety latches #8
diagonally across from
diagonally across from
each other.
each other.
Safety Latch #8
(in right-hand hole)
Publicidad
