Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly.
Caution! The fan should always be switched off and does not connected
to the mains supply, if you mounting the fan.
- To fix the base to the body fan, set the fan gently on the head. Use a soft
surface to not damage the top of the product.
- Add the 2 halves of the base together and set them on the body fan.
- Fix the base with the provided screws on the body fan. Make sure the
cable is not clamped.
- Fix the cable with the preassembled strain relief as showed in the
picture below (picture number 1).
Pay attention that all the parts are correct and firmly connected with each
other.
Caution! Connect to the mains supply only after the fan has been fully
assembled.
- The fan must not be used without a fixed base
- The device may be operated only in straight and upright position
- This device may not be used in a horizontal position
Before plug the product check if it is switched Off. Insert the plug of the
fan into a suitable socket outlet. Set the speed/oscillation using the knob
as below:
1 = low speed
2 = middle speed
3 = high speed
off = off
1
= low speed with oscillation
2
= middle speed with oscillation
3
= high speed with oscillation
14
Instructions for use
Picture 1
Publicidad
