brondell LH-22 Manual Del Propietário página 11

CONNECTING THE HOT WATER SUPPLY (cont.)
4 . If it hasn't been removed already, unscrew the
Pressure Cap covering the Pressure Connector .
a . Slide the Pressure Cap over the open end of
the of Hot Water Flex Tubing with the inside
threads facing towards the open end .
b . Push the Hot Water Flex Tubing over the
Pressure Connector .
IMPORTANT: Be sure to slide the Hot Water
Flex Tubing over the Pressure Connector until
the tubing slides past the "lip" of the pressure
connector and it cannot go any further.
c . Slide the Pressure Cap down until the cap
meets the Pressure Connector . Screw the Cap
onto the T-Valve until secure and tight .
Caution: Do not over-tighten the Pressure Cap .
You will risk damaging the tubing .
Step 4a
Step 4b
Step 4c
9