brondell LH-22 Manual Del Propietário página 13

INSTALLING THE BIDET ATTACHMENT (cont.)
3 . Connect Hot Water Supply to Bidet Attachment
a . Slide the Pressure Cap over the open end of
the of Hot Water Flex Tubing with the inside
threads facing towards the open end .
b . Push the Pressure Connector into the open
end of the of Hot Water Flex Tubing with the
washer facing out .
IMPORTANT: Be sure to slide the Hot Water
Flex Tubing over the Pressure Connector until
the tubing slides past the "lip" of the pressure
connector and it cannot go any further.
c . Hold the Pressure Connector up against the
hot water inlet on the bidet attachment . Slide
the Pressure Cap along the tubing and screw
the Cap onto the hot water inlet until the
Pressure Connector is secure .
4 . Turn on Water Supply & Check for Leaks
a . Open the hot and cold water supply valves
slowly and check for leaks .
b . Wait 5-10 minutes, check again and if there are
no leaks continue .
Note: If there is any leaking, check all rubber
washers and make sure all water connections
are tight and secure. If necessary, you can use
plumbers tape for any leaking connections.
Step 3a
Step 3b
Step 3c
11