Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
USING THE SOUTHSPA
If only connected to cold water, make sure that the
temperature dial on the bidet attachment is turned
as far as it can go towards "COLD" setting for best
pressure adjustability .
To adjust water temperature (when both hot and cold
water are connected), turn temperature dial slowly
towards "HOT" until the desired temperature is
reached .
Note: There may be a delay in the warm water
reaching the bidet attachment as the cold water
in your pipes clears and is replaced with hot water
(similar to the delay when you turn your faucet on).
Tip: For a quick and easy way to get warm water to
the bidet, run the "Nozzle Cleaning" function with the
warm water turned on for a short time until the water
heats up, then use as normal.
For the general bidet wash function, turn the dial towards either the Front (also
known as the Feminine) wash position, or the Rear (also known as the Posterior)
wash position .
• The further the dial is turned, the higher the water pressure will be .
• To lower the water pressure, turn the dial back towards the center .
To clean the bidet nozzle, turn the control dial towards the "Nozzle Cleaning"
position and water will wash over the nozzles .
WARNING: Risk of scalding . High water temperature can cause severe burns .
Be sure to set the water temperature for your hot water heater at or below
120°F (49°C) and use extreme caution when mixing hot and cold water during
use . Brondell is not liable for any misuse of product or failure to use caution
when connecting to hot water .
NOZZLE POSITIONING
The nozzles can be easily adjusted by gently pulling the end of the nozzle forward
or backwards . Once desired position is set, the nozzle will remain in that position
until manually moved .
12
Publicidad
